Filter
Top Products
English
13
DRAIN HOSE
10. Cut a 1-1/2” (3.8cm) diameter hole in cabinet wall
or floor on the side of the opening closest to the sink.
11. Connect drain hose to waste tee or waste disposer
following one of the following methods:
*An air gap is recommended
an air gap
11a.
no air gap* 11c.
an air gap 11b.
no air gap* 11d.
a waste disposer
no waste disposer
11a. WASTE DISPOSER & AIR GAP
1. Remove the disposer knockout plug. Cut end of drain
hose “I” if needed (do not cut ribbed section).
2. Attach drain hose to air gap “J” with large spring-type
clamp “K”. If the drain hose was cut, use a 1-1/2” to
2” (3.8 to 5 cm) screw-type clamp*.
3. Use a rubber hose *connector “L” with spring or screw-type clamps* “M” to
connect air gap to disposer inlet “N”. The connection “N” MUST be made
before drain trap “O” and at least 20” (50.8cm) above the floor where
dishwasher will be installed. Go to step 12.
11b. NO WASTE DISPOSER & AIR GAP
1. Cut end of drain hose “I” if needed (do not cut ribbed
section).
2. Attach drain hose to air gap “J” with large spring-
type clamp. If the drain hose was cut, use a 1-1/2” to
2” (3.8 to 5 cm) screw-type clamp*.
3. Use a rubber hose *connector “L” with spring or screw-type *clamps “M” to
connect air gap to waste tee “P”. This connection “P” MUST be made before
drain trap “O” and at least 20” (50.8 cm) above the floor where dishwasher
will be installed. Go to step 12.
* Parts available from local pumbing supply stores.
8. Turn shutoff valve “H” to “ON” position. Flush water into a
bucket to get rid of particles that may clog the inlet valve.
9. Turn shut-off valve to “OFF” position
P