Filter
Top Products
English
25
CHECK OPERATION
1. Read the Use and Care Guard included with your dishwasher.
2. Check that all parts have been installed and no steps were skipped. Check
that you have all the tools you used.
3. At fuse box or circuit breaker, turn on electrical power supply to dishwasher.
Start dishwasher and allow it to complete the shortest wash cycle. After
the first two minutes, unlatch door, wait five
seconds, then open door. Check to see that
there is water in the bottom of the dishwasher
and that there are no water leaks.
4. Check that grounding clip “A” is attached to
the lower panel. Place the lower panel “B”
behind the access panel “C”. Some models
have insulation “D” on the access panel which
must fall behind the insulation “E” on the lower
panel. Hold the two panels together and place
them against dishwasher leg.
Reinstall the screws through the holes in the
access panel and the slots in the lower panel.
Install right side screw first. Check that the
lower edge of the lower panel contacts the
floor. Tighten the screws.
If dishwasher does not operate:
• Has the circuit breaker tripped or the house fuse blown?
• Is the door closed tightly and latched?
• Has the cycle been set correctly to start the dishwasher?
• Is the water turned on?