Filter
Top Products
English English
11
PreParing before use
1. Remove all packaging material This includes foam base, corner posts,
adhesive tape. etc.
2. Check to make sure all parts and materials are available in the fridge.
Consult the seller for help if you find parts are missing.
3. Place the refrigerator in a good location (See “Location”).
4. Toe grille installation: Open the door of the lower freezer and remove the
lower freezer compartment bin. Install toe grille with screws from bag as
shown.
5. For the convenience of record keeping, the model and serial number,
purchase date, and receipt should be copied and taped to this manual for
safekeeping.
6. It is recommended to clean the refrigerator before use. Before putting food in
the refrigerator, please clean the inside and outside with water and diluted
baking soda. Dip clean cloth in gallon of water and spoonful of baking soda.
7. Position the fridge then plug it in. After the refrigerator is placed on a flat
surface and cleaned, turn on the power then let it run a few hours, then begin
loading it with food.
Usage
1. Plugging in the power cord: After turning on the power, the factory pre-sets
will be in effect, the default value of time is 12:00 PM, and the dispenser
control center is in unlock mode.
2. After plugging in the unit, change the settings to the temperature desired.
3. Putting the food into the refrigerator: The refrigerator will be cooled completely
after a period of a few hours. Frozen and fresh foods can be put into the
refrigerator for normal use.
When changing box temperatures, a new balance temperature will occur after a
period of time. The length of this period of time depends on the degree of the
temperature change, the ambient temperature, the frequency of door openings,
and the amount of stored food in the fridge.