Filter
Top Products
English English
20
Before putting hot foods into the refrigerator, first let cool until they reach room
temperature. Foods stored in the refrigerator should be cleaned and the water
drops patted off after cleaning. Before foods are put into it the refrigerator to
be stored, it is recommended that the foods should be pressurized, so that the
water cannot vaporize, and the fruits and the vegetables can keep fresh, and the
smells of the foods will not mix together. Stored foods can be marked in bags.
Store the foods independently according to the different kinds of foods. Daily
eaten foods should be stored in the front of the shelf. Try avoiding frequent door
openings that reduce food shelf life. When storing food in the fresh food section
make adequate space for air flow circulation. This helps maintain the shelf life of
the food. When you store the foods, you should make sure that the foods stored
in the refrigerator are not too close to the liner to avoid foods freezing on the
back or side walls of the refrigerator. So you should store food making sure that
there is at least some space between the foods stored and the inside walls.
It is suggested for radishes and other root vegetables to trim the leaves before
storage. This keeps nutrients in the root so the leaves do not absorb them. Put
the refrigerated foods into the fresh food area to let them defrost. The low
temperature of the refrigerated foods reduces the formation of bacteria and
extends food life. Some foods like onions, garlic, bananas, and root vegetables
are better stored at room temperature than in the fridge. Melon, pineapples, and
bananas can go directly into the freezer after preparing if storing over longer
period.
• The freezer is suitable for storing food for a long time. The temperature inside
the freezer is low (between -2 and 8 degrees F). It keeps foods fresh for a
long period of time. Frozen foods should be wrapped and marked when
entered to track storage time period.
How to change the freezer light bulb:
The electrical rating of the bulb is: 115V, 60 Hz-40W.
The lamp holder is type E17. (Never use bulbs with power over 40W.)
While changing the light bulb:
• Pull out the power cord plug to cut off the power.
• Lift the light-shield slightly in the direction upward, and then pull it out in the
direction shown.
• Turn the bulb counterclockwise and drop it down, then install a bulb of the
same rating.
• Install the light-shield in the reverse order.
fresH fooD storage tiPs
about tHe freeZer