English English
18
• Short term fresh or frozen food can be placed in the upper fresh food section
or in the center freezer drawer. Keep raw foods near the lower area, away
from ready to eat food in the top area.
• The height of the cantilever shelves can be adjusted to fit your storage needs.
When adjusting the height of the shelf, first remove any foods placed on the
shelf. Then lift up by tilting the front up, and pull it up. This will unlatch the
rear hooks. Then place the hooks in a new ladder slot location and tilt back
down into position on an even, horizontal plane. (See pictures to the right.)
Caution! Make sure that the two sides of the shelf are in balance, otherwise, the
shelf may fall down or the food may drop.
• Crisper use
The refrigerator is designed to include a fruits, vegetables, and/or deli crisper.
Its inside temperature can be adjusted according to the type of food being
stored.
• Turn up the humidity control button on the right side of the crisper, for a high
humidity, to store cucumbers, grapes, oranges, apples, peaches, lettuce, and
other produce that’s high in moisture.
• Turn down the humidity control button on the right side of the crisper to lower
the humidity. This is suitable for storing meats, cheeses, onions, tomatoes and
other drier foods.
• Full-width pantry and its usage
The refrigerator is specially designed to include a full-width pantry. Its inside
temperature can be adjusted, depending on the type of food to be stored there.
Note: Don’t press the air-adjusting button too hard, to avoid damage.
Door bin height adjustment and cleaning
To change location, lift up the door bin while holding it by its two sides, and pull
it straight out. After being cleaned, the door bin can be installed in the reverse
manner, and the position can be adjusted according to the height of the food to
be stored.
Crisper cover removal
Lift up the shelf, then pull it straight out in the direction shown.
Caution! When adjusting the height of the door bin, it is better to keep the
dairy bin above the door bin.
fooD storage tiPs