Filter
Top Products
Replacement Parts
Maintenance
Unplug the unit and remove the container from the base, and then inspect the container
and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary.
If the blades are loose, discontinue use immediately and replace the blades.
See “Replacement Parts” below.
Unplug the unit, and then inspect the power cord insulation and power plug for cracks.
Refer to “Requesting Assistance or Service” for repair or replacement.
Replace the container and cutter assembly at least every 90 days.
See “Replacement Parts” below.
64 oz. container 6126-1200
Cutter assembly 961200
Ice shaver blade assembly SB1200
Shaver belt 990028700
Blender belt 990028800
Blender motor brush kit 990028900
Blender motor assembly 990029000
Chute cover/splash shield 990029100
Inner ice hopper 990029200
Ice hopper cover 990029400
Jar pad 990029500
Drive bearing assembly with clutch 990029600
Pre-programmed memory card MC1200
Container lid with filler cap 990029800
Drain hose 990029900
Controls panel 990030000
Agititator/thumbscrew/O-ring 990030200
Shaving pool with chute 990030300
Hopper isolation grommets 990030400
Main PCBA assembly 990030500
Speed/revolution sensor 990030600
Leveling foot/jam nut 990030700
Belt tensioner assembly 990030800
Inner hopper/Hopper lid interlock switch 990030900
Part Description
Part Number
Inspect the blender and its various parts and replace as follows:
Daily
Weekly
Quarterly
Refer to “Technical Service” to order parts below.
15
Caring for the Ice Shaver/Blender