Filter
Top Products
10
Operating the Blender
Program Cycles
Cycle Descriptions
The Cycle buttons on the Control Panel
allow you to select the program cycles
described below:
Each cycle’s speed fluctuates in a prepro-
grammed combination of pulses to blend
a specific type of drink. See the charts
below and the diagrams on page 2 for
detailed descriptions.
To end a cycle, press either STOP or
any cycle button. DO NOT remove the
container while the unit is running.
You cannot change cycles while the unit
is running by selecting a new cycle on
the Control Panel.
Pre-Programmed Blending Profiles
Profile Button Time Suggested Applications
0 30 Sec. For smoothies with IQF
(Individually Quick Frozen)
fruit.
1 25 Sec. For smoothies with dairy products
and milkshake blends.
2 23 Sec. For smoothie concentrated mixes, margaritas,
daiquiris, and iced cappuccinos
3 15 Sec. For thin consistency drinks.
4 26 Sec. For thick specialty drinks.
5 60 Sec. For soups, salad dressings, sauces, and dips.
Additional Blending Profiles (Optional–see Programming Section, page 9)
Profile Button Time Suggested Applications
6 — 25 Sec. For controlled blending of ingredients.
7 — 20 Sec. For small batches of thin consistency drinks.
8 — 20 Sec. For quick, homogenized blending.
9 — 30 Sec. For general blending.
NOTE: You may wish to experiment with each cycle to determine the most effective blending
cycle for commonly-made drinks. You may vary the time for each profile based on the size of
the batch/drink you are most commonly blending.
For instructions on programming the cycle buttons, see page 9.
A-840083400B-ENv01 11/30/01 3:57 PM Page 10