Filter
Top Products
8
Operating the Blender
Using the Control Panel
Before operating the blender, read the Using the Control Panel and Program Cycles sections on
the following pages to better understand these features. Then, refer to the Using the Blender
section on page 11 for specific operating instructions.
STOP button
Stops operation
of the selected
function.
Does not shut
off power to
the blender.
Cycle buttons A–F
Press any cycle letter A–F to run that cycle.
Press any button to stop the blender.
RUN up/down buttons
Press the RUN ▲ or ▼ button to start the
blender and run at that speed.
Press and hold the RUN ▲ or ▼ button
until the desired speed is reached.
LCD display
see below
for status
messages
PULSE up/down buttons
Press the PULSE ▲ or ▼ button to start
the blender. Release to stop.
The display will show the programmed
speed percentage.
To change the speed settings of the
PULSE ▲ or ▼ button, press and hold
the RUN ▲ or ▼ button while holding the
desired pulse button.
LCD status messages
appears when the container is removed.
appears if the container is on the base and
the unit is ready.
appears if the container is on the base and
the unit has been idle for 1 minute or more.
appears in the event of motor or circuit failure.
Contact Hamilton Beach Commercial service.
To Display Cycle Count:
Press STOP for 10 seconds. Press the PULSE ▲
button to display the cycles. Press STOP to return
to operation mode.
A-840083400B-ENv01 11/30/01 3:57 PM Page 8