Filter
Top Products
9
The blender comes with 10 pre-installed cycle profiles. These profiles can be assigned to any
cycle button A–F. For a detailed description of these pre-installed profiles, see page 10. The
blend time and speed for each profile can also be custom programmed to suit your needs,
allowing unlimited cycle options. In the following example, cycle button A is being programmed.
NOTE: The container must be in place before performing any of the following procedures.
To Program Cycles
1. To enter programming mode, press and hold
STOP for 10 seconds, then release.
2. Press the desired cycle button A–F.
For this example, press A.
3. Press the PULSE ▲ button until the desired
profile 0–9 is selected. See pages 2 and 10
for descriptions.
4. Press the button of the Cycle A–F shown at
the top of the display.
5. Press the PULSE ▲ button to increase the
seconds by 10. Press the PULSE ▼ button to
increase the seconds by 1.
6. Once the desired time is set, press the
button of the Cycle A–F shown at the
top of the display.
7. Press another Cycle button A–F to continue
programming, OR press STOP to exit pro-
gramming mode.
To Reset to the Factory Default Profile Settings
1. Press STOP for 10 seconds.
2. Press RUN ▲ for 10 seconds.
3. Press STOP to exit programming mode.
The word “Program” is blinking.
“Profile” is blinking to indicate that you are in
Profile mode. “0” was the last profile assigned
to Cycle A.
Profile 1 was chosen for this example.
“Time” is blinking to indicate that you are in
Time mode. The display will now show the time
on the cycle.
Time 0:45 was chosen for this example.
The display will now return to the display shown
in step 1.
Operating the Blender
A-840083400B-ENv01 11/30/01 3:57 PM Page 9