Filter
Top Products
Page 10
SKU 94559 For technical questions, please call 1-800-444-3353
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Make sure the On/Off Button and Safety Button of the Meat Slicer are in
its “OFF” position and that the tool is unplugged from its electrical outlet before per-
forming any inspection, maintenance, or cleaning procedures.
1. Before each use, inspect the general condition of the Meal Slicer. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use. Do
not use damaged equipment.
2. After each use, wash all components (including the Blade) with warm soap and
water. Do not immerse the Main Body (9) in water.
3. Periodically recheck all nuts, bolts, and screws for tightness.
4. Before storing, remove the Food Tray (71) and Food Pusher (67), then unlock the
Soleplate (28) by moving the Push-Pull Button (22) to the left. Push up the Soleplate
all the way, then lock in place by moving the Push-Pull Button (22) to the right
position.
5. Store the Meat Slicer and components in its packing box or a plastic bag, and place in
a clean and dry location.
Removing the Cutting Blade
1. With the Meat Slicer unplugged, turn the Blade
assembly latch clockwise to loosen and remove
the Blade. Handle the Blade with cut-resistant
gloves.
2. To replace the Blade, insert into its housing until
its tabs are seated, then turn the Blade assembly
latch counterclockwise until it is completely
tighten.
Caution: Avoid cuts. Handle Blade with care, it is very sharp.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR
SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.