Filter
Top Products
11
Installation of Ducting
Installation through an outside wall
range hood outlet (see Figure 4, Page 10), making sure no wall studs are cut. Push range into position. From outside of
the house, measure distance from the siding to the range outlet. Cut duct pipe that length, plus 1” (25mm) for overlap into
outlet. Mechanically attach vent hood to pipe. Caulk the back of vent hood and around pipe where it goes through wall
and into range hood outlet so caulking seals against outside siding.
Complete installation by following directions under Ventless Installation.
Installation through an attic to an outside wall
If the vent elbows are embedded in the wall, the range may be positioned as shown in Figure 5, Page 11. Continue the
through the roof with a roof cap. Seal with caulking around and under cap or hood.
Complete your installation by following directions under Ventless Installation.
14”
36 cm
28”
72 cm
29-1/2”
75 cm
RangeHoodOutlet
3-1/4” x 10”
8 cm x 25 cm
66-1/4”
169 cm
56”
142 cm
36-1/8”
92 cm
Gas Inlet-1/2” NPT
Power
Cord
Exhaust
Hood
(female)
Receptacle
20”
51 cm
4-3/4”
12 cm
30”
76 cm
39-3/4”
101 cm
47-1/2”
122 cm
Figure 5
Model 7200
13”
33 cm.
29-1/2”
75 cm
28”
72 cm
56”
142 cm
66-1/4”
168 cm
62-3/8”
159 cm
29-3/4”
76 cm
36-1/8”
92 cm
13-3/4”
35 cm
RangeHoodOutlet
3-1/4” x 10”
8 cm x 25 cm
3-3/4”
10 cm
34”
86 cm
Gas Inlet-1/2” NPT
Power
Cord
Exhaust
Hood
(female)
Receptacle
Figure 6
Model 9200