Filter
Top Products
6 • 705 & 705S OWNER/OPERATOR MANUAL
WARNING
FOR PERSONAL SAFETY, THIS TENDERIZER WILL NOT OPERATE WITHOUT THE
SAFETY NECK IN PLACE. NEVER RAISE OR LOWER THE SAFETY NECK WITH THE
MACHINE TURNED ON, BOTH FOR PERSONAL PROTECTION AND MACHINE PROTEC-
TION. ALWAYS TURN MACHINE OFF WHEN NOT IN USE. ONLY RUN MACHINE BY
USING THE ON/OFF SWITCH, NEVER BY RAISING OR LOWERING THE COVER.
5. Uncoil power cord and plug into a grounded, approved outlet. (Specifications for this machine
are found on the serial plate located on the left-hand leg.)
6. Push ON/OFF rocker switch to ON. If cutting knives do not rotate, turn machine OFF and
unplug power cord. Lack of rotation indicates that the clutches are not engaging. Raise the
safety shield and slide the assembly to the left. Lower safety shield, plug in power cord and turn
ON.
THE TENDERIZER IS NOW READY TO USE.
CLEANING & MAINTENANCE
1. Turn off machine and unplug power cord.
2. Remove safety cover by raising cover and pulling the spring loaded pivot knob to your left. Lift
out.
3. Hand wash and rinse the safety cover and set it aside to air dry. Sanitize with an approved
sanitizer before reassembling. Only use an approved sanitizing solution, Berkel part number
4975-00400.
WARNING
TO PREVENT CUTS, ALWAYS WEAR APPROVED
SAFETY GLOVE WHEN HANDLING STIR-FRY BLADES.
4. Grip the blade and frame assembly at the center of the frame sides. Move to the right to disen-
gage from the clutch. Lift out and set it on a working surface.
5. Push down the locking plate on the right side of the assembly.
WARNING
KNIVES ARE SHARP. ONLY HANDLE BLADES AND KNIVES
BY THE SHAFT ENDS TO AVOID CUTTING HANDS.
6. Grasp both ends of front blade assembly and lift out of frame. Set it back out of the way. Do the
same with the rear blade assembly.
7. Lift out front stripper plate.
8. Remove back stripper plate by rotating up and out.
NOTE: There is no back stripper plate on a stir-fry assembly.
705 Tenderizer Technical Manuals Page 12 of 34