Filter
Top Products
– 13 –
OPERATION
PREPARATION
Place the pump strainer (when equipped), overflow tube, overflow cover, end cover, slanted strainer,
and the strainer bucket in their respective positions, (Fig. 7).
Fig. 7
An automatic detergent dispenser is recommended. Closely follow supplier's instructions. If no
automatic dispenser is used, scatter the initial charge of detergent on the slanted strainer. Replenish
as needed.
Close the doors which will automatically close the drain. On model AM14: The front inspection door
must be closed before the counterbalanced doors can be lowered.
Open the manual steam (globe) valve or gas valve (if applicable). Push the P
OWER switch ON (Fig. 8).
If all machine doors are closed, the fill cycle will begin automatically. During the fill cycle, the word FILL
will flash intermittently on the control box readout (Fig. 8). NOTE: If the fill cycle did not begin
automatically, make sure that the C
YCLE SWITCH (Fig. 8) is on AUTOMATIC and the WASH / RINSE switch
(Fig. 8) is OFF.
When the fill cycle has completed, the readout will display the wash temperature. During the rinse
cycle, the rinse temperature will be displayed.
Fig. 8
PL-40467-1
Control Box Readout
Power Switch
Cycle Switch
Wash/Rinse
Switch
WASH / RINSE
SWITCH
POWER SWITCH
PL-41177-1
CYCLE SWITCH CONTROL BOX READOUT