Filter
Top Products
– 4 –
Installation, Operation, and Care of
MODEL AM14 & AM14C DISHWASHERS
SAVE THESE INSTRUCTIONS
GENERAL
The AM14 dishwashers are semi-automatic rack-type machines. On model AM14, the doors open on
opposite sides of the machine allowing the rack to move straight through. Model AM14C can be located
in a corner; adjacent doors open so the rack moves in and out at a 90° angle. The AM14 and AM14C
dishwashers are designed to operate in one of two modes: Hot water sanitizing mode (designated by
the letter "H" at the end of the machine serial number), or a chemical sanitizing mode (designated by
the letter "L" at the end of the machine serial number). The serial number can be found on the machine
data plate.
Model AM14 Model AM14C
with Booster Heater shown
Fig. 1
DO NOT attempt to operate this dishwasher in the chemical sanitizing mode without a properly
installed, NSF-listed, chemical sanitizer feeder (not supplied with machine). Contact an authorized
detergent representative for information about a chemical sanitizer feeder.
The pump motor is rated 1 H.P. and has thermal overload protection.
The fill line incorporates an atmospheric vacuum breaker to prevent any reverse flow of water from the
dishwasher into the potable water supply.
A float, located in the wash tank, will shut off the heat supply if the water level becomes too low. When
the water returns to a proper level, the heating circuit is again operational.
A frame-mounted 13KW electric booster water heater is available as an option on machines equipped
with electric tank heat. The booster water heater is designed to maintain a minimum final rinse
temperature of 180°F provided the incoming water to the booster heater is at least 110° F.
Also available as an optional accessory is the model IB57 Infrared Booster Gas Water Heater.