Filter
Top Products
– 27 –
SYMPTOM POSSIBLE CAUSE
Inadequate Rinse. 1. Dirty line strainer (Fig. 5) causing reduced water flow. Turn off
water supply, remove strainer cap and withdraw and clean screen.
Reassemble.
2. Low supply line pressure.
3. Clogged rinse nozzle(s).
Continuous Rinse 1. Rinse actuator (Fig. 16) not moving freely.
Operation. DISCONNECT THE ELECTRICAL POWER TO THE MACHINE
AND FOLLOW LOCKOUT / TAGOUT PROCEDURES. Check
actuator for movement.
Fig. 16
2. Check for foreign object in mechanism, i.e., silverware.
3. Rinse valve failed or jammed open.
4. Contact your local Hobart Service office.
No Wash Tank Heat. 1. The machine is equipped with low water safety devices which shut
off heat, if water level drops. Check for proper water level.
2. Circuit breaker to heat system tripped.
3. Check heat float for debris and free movement.
4. Steam supply valve not open completely.
5. Overtemp protector tripped.
6. Contact your local Hobart Service office.
No or Slow Fill. 1. Dirty line strainer (Fig. 5) causing reduced water flow. Turn off
water supply, remove strainer cap and withdraw and clean screen.
Reassemble.
2. Make sure doors are closed.
3. Check both upper and lower fill floats for debris and freemovement.
4. Problem with solenoid valve.
5. Drain leaks.
NOTE: If symptom(s) persists after possible causes have been checked, contact your local Hobart
Service office.