Filter
Top Products
– 2 –
Operation and Care of
FT900 SERIES DISHWASHERS
SAVE THESE INSTRUCTIONS
OPERATION
MACHINE PREPARATION — Check before beginning operation.
Raise the machine doors and make sure all components are in their proper operating positions.
Pump Intake Screens must be put on
holders at each pump intake (Fig. 1).
Fig. 1
Strainer Pans must be in place on top of
each tank (Fig. 2).
Fig. 2
End Caps must be correctly installed at
ends of all Wash Arms (Fig. 4).
Fig. 4
Wash Arms must be properly installed
and latched in place (Fig. 5).
Fig. 5
The Final Rinse Arm must be properly
installed (Fig. 7).
Fig. 7
Final Rinse Actuators must move freely,
if so equipped (Fig. 8).
Fig. 8
Curtains must be in their proper
places (Fig. 30, pages 9-11) . . .
A Short Curtain on the unload
side of each upper Prewash,
Wash, and Power Rinse Arm,
Long Curtains on both sides
of every section divider,
Two Long Curtains at the Load
End.
Strainer Baskets must be in place in
Strainer Pans (Fig. 3).
Fig. 3
The Flush Arm at load end must be
properly installed (Fig. 6).
Fig. 6
© HOBART CORPORATION, 1998