Hobart FT900BD Dishwasher User Manual


 
17
Entering the Parameters Menu
NOTE: The parameters can be changed anytime the display is active, which is when the machine is
operating or in idle mode.
To enter the Parameters menu to edit options:
1) Press the MENU key from the main screen.
a. You will be prompted on-screen asking if you wish to exit the menu.
2) Press the UP or DOWN key repeatedly until you reach the
ENTER SECURITY CODE? screen.
3) Press the ENTER key to indicate that you want to enter the code.
a. You will now be prompted with S
ECURITY CODE: on the top line and a single digit and three
asterisks [ 0
***
] on the bottom line.
4) Use the UP and DOWN keys to change the digit of the Security Code to the appropriate value*.
* The default Security Code to enter Manager Mode is 1001. This code can be changed by anyone with this knowledge and
it is recommended to change it from the default. If the code is ever lost for some reason, it can be reset by Hobart Service.
NOTE: Resetting the code is not covered under your warranty, whether you are in the initial warranty period or in the extended
warranty period.
5) Press the ENTER key to move to the next digit to the right.
6) Repeat steps 4 and 5 for each digit.
a. After pressing ENTER on the fourth digit, you will immediately return to the E
NTER SECURITY
CODE? screen.
7) You will know you entered the code correctly if the letter in the lower left corner reads M. Refer
to Machine Operation and Programming Security Levels on page 15 for more details on other
letters that may appear.
a. If it does not match, repeat steps 3 through 7.
b. If it does match, continue to step 8.
8) Press the UP or DOWN keys repeatedly until you reach the
EDIT PARAMETERS? screen.
a. If you do not see this screen after scrolling all of the way through, the Security Code was not
entered properly. Repeat the steps starting from 2.
9) Press the ENTER key.
a. You are now in the Parameters edit menu; the display shows the first editable parameter.
Navigating the Parameters Menu
NOTE: The security level must be elevated to the Super Operator or higher to enter the Parameters
Menu. Refer to Machine Operation and Programming Security Levels on page 15 for more details.
Hobart believes that the default settings that leave the factory are suitable for the majority of kitchen
operations. However, there are cases where kitchen managers may find the need to change one or
more options (Parameters Menu Table 1); the Parameters Menu allows these changes.
Within the Parameters Menu, the manager (or operator, in some cases) may modify factory default
settings. The menu structure and description of each option are detailed below. Please contact Hobart
Service if you are uncomfortable changing any setting or are unsure of which one(s) to change.