Filter
Top Products
– 11 –
LIGHTING THE DGC1 AND HGC40/HGC60 OVENS
Turn manual gas valve ON. Turn ON/OFF/COOLDOWN switch ON and turn thermostat to its maximum
setting. Both the ON and HEAT lights should come on. If HEAT light is not on, make sure door is closed.
After 5 seconds, the spark ignition system will start and the solenoid valve will open, allowing gas to
flow to the burner for 7 seconds. This 5-second purge and 7-second ignition trial will repeat up to two
more times if the burner does not light within the first 7-second ignition trial. During this 5-second
prepurge, the red NO IGNITION light will be lit.
When the burner gas ignites, a slight "roar" will be heard. This "roar" is a normal condition of the power
burner and will become almost undetectable in the normal operating mode after warm-up. The NO
IGNITION light will go off when ignition occurs.
If the burner fails to light after three trials, the red NO IGNITION light will be lit and remain on. Turn
ON/OFF/COOLDOWN switch OFF for five minutes before repeating lighting sequence previously
described.
If the burner does not light after three trials, turn off the manual gas valve and call a qualified servicer.
USING THE DGC1 AND HGC40/HGC60 OVENS
Preheating
1. Turn ON/OFF/COOLDOWN switch ON. The amber ON light will come on, indicating that power to
the oven is on.
2. Set THERMOSTAT as desired. Refer to COOKING GUIDELINES for suggested temperatures and
times for various products.
3. Prepare product and place in suitable pans. When the white HEAT light goes off, the oven has
reached desired preheat temperature.
Cooking
1. Open doors and load the product into the oven. Place pans in the center of the racks. Close doors.
2. Set the TIMER. After the preset time lapses, turn timer to OFF position to stop the buzzer.
4. When product is done, open doors and carefully remove cooked product from the oven. Wipe up
any spills.
End of Day
• Turn THERMOSTAT to OFF.
• Turn ON/OFF/COOLDOWN switch to COOLDOWN.
• Leave door ajar while the fan is on to cool the oven.
• When oven has cooled sufficiently, turn ON/OFF/COOLDOWN switch to OFF and clean oven.