Hobart HGC40 Convection Oven User Manual


 
– 15 –
Pulse Button
Selects the pulse time setting. A cook time must be set first. The pulse time can then
be set equal to or less than the cook time. The pulse time will be the portion of cook time
to operate in the pulse mode. Pulse mode will start first. When pulse time elapses, the
remainder of the cook time will be in the non-pulse mode.
Use when cooking delicate product, such as strudel, muffins, cupcakes, meringue pies,
etc., to keep product from forming "waves" on the top.
Use the Pulse Button to switch between the selection of pulse mode and no pulse mode
time setting. A pulse mode time of zero means no pulse mode will occur.
The light in the Pulse Button will be lit when in the pulse mode.
In Pulse Mode:
1. The fan cycles (45 seconds ON and 45 seconds OFF) for the duration of the
pulse cycle time.
2. The fan stays on while the heat cycles in hold mode.
3. The fan stays on while heat cycles at 100% power when not timing.
4. Can be switched at any time.
Stop/Start Button
1. Initiates timing a product in the mode selected if a cook time has been set.
2. Stops timing of a product if a timing sequence has already started.
Hold Button
Selects Hold mode.
1. Allows selection of hold temperature.
2. Temperature indication of ---°F (---°C) indicates no hold mode.
Hold Button Light
Is lit when in the Hold mode.
1.
When not timing, allows setting/enabling a hold mode setting of ---°F
(---°C), meaning no hold will take effect.
2. Any other temperature means that when the actual cook time has ended, the
oven will enter the Hold mode and use the hold temperature.