Filter
Top Products
– 11 –
BOWL PLACEMENT
The bowl must be installed before the agitator is installed.
To install the bowl, fully lower the bowl support. Position bowl so the alignment pins on the left side of
the bowl support fit in the holes in the bowl. Swing the bowl into the locked position on bowl support.
AGITATOR
To install an agitator, the bowl must be on the bowl support and fully lowered.
To Install
1. Open the wire cage.
2. Place the agitator inside the bowl and line up the
horizontal slot on the agitator with the agitator shaft
pins.
3. Slide the agitator up the agitator shaft until it stops
and latches.
To Remove
1. Open the wire cage.
2. Lower the bowl by pressing and holding the down
arrow on the bowl switch.
3. Hold the agitator and pull the plunger of the agitator
out (Fig. 3). Slide agitator down off the agitator
shaft.
POWER BOWL LIFT
CAUTION: Before lowering the bowl onto a bowl truck, always unlock bowl and swing bowl out
slightly.
To raise the bowl, the bowl must be in the locked position. Push and hold the up arrow on the bowl
switch. To lower the bowl, push and hold the down arrow on the bowl switch.
To Raise the Bowl While Mixing
To raise the bowl while the agitator is mixing the product (when required by recipe or when using the
Bowl Scraper Attachment):
1. Close the wire cage, then select a mixing speed on the SPEED dial.
2. Select a count-down time or HOLD for continuous count-up mixing.
3. While pressing and holding the up arrow on the bowl switch, press and hold the START button.
The mixer runs only in stir speed while the bowl is rising.
4. When the bowl reaches the mix position, release the START button. The mixer automatically
changes to the selected mixing speed.
Fig. 3