Hobart HL661 Mixer User Manual


 
– 18 –
Transmission
To check the oil level, remove the top cover, which is secured by two screws. Remove the
Transmission Fill Plug (Fig. 8) and check the oil level. If the oil level is below the line on the oil dipstick,
add a small amount of the recommended transmission oil until it returns to the proper level. Do not
overfill the transmission, as leakage may result. Contact your local Hobart Service Office for the
recommended transmission oil.
Fig. 8
ADJUSTMENTS
Agitator Clearance
The agitator clearance should be checked periodically. The agitator must not touch the bowl, and the
maximum clearance between the bottom of the bowl and the B flat beater is
1
/8" (3 mm); the maximum
clearance between the bottom of the bowl and the ED dough arm is
5
/16" (8 mm).
Install a bowl and agitator (e.g., beater). If the bowl and beater come into contact before the bowl support
reaches its stop, adjust the stop screw. Refer to Adjust the Bowl/Agitator Clearance, page 19.