Filter
Top Products
– 19 –
Measure Clearance
Pour enough flour in the bowl to cover the bottom of the bowl where the beater travels. With the bowl
fully raised (beater should not touch the bottom of the bowl), briefly run the mixer at the lowest speed.
Turn off the mixer, disconnect the electrical power supply, and measure the depth of flour where the
beater has traced a path. This measurement should be taken at several points around the bowl to
assure accuracy.
Adjust the Bowl/Agitator Clearance
• Remove the apron (which is secured by thumbscrews).
• Adjust the stop screw on right side.
- Loosen the bottom locking nut, (Fig. 9) and
turn the stop screw counterclockwise to
increase the clearance or clockwise to
decrease the clearance.
- Tighten the locking nut while holding the stop
screw.
• After the adjustments are made, replace the
apron and secure it with the thumbscrews.
• Reconnect the electrical power supply.
• Carefully operate the bowl lift several times to
check the adjustment.
Fig. 9