Filter
Top Products
– 10 –
BOWL PLACEMENT
NOTE: The bowl must be installed onto the bowl support before the agitator is installed.
To Install
1. Fully lower the bowl support.
2. Position bowl so the alignment pins on the left
side of the bowl support fi t in the holes in the
bowl.
3. Swing the bowl into the locked position on bowl
support (Fig. 6).
To Remove
1. Lower the bowl by pressing and holding the
down arrow on the bowl switch.
2. Unlock bowl and swing out slightly from locked
position
3. Open wire cage and remove agitator.
AGITATOR
To install an agitator, the bowl must be on the bowl support and fully lowered.
To Install
1. Open the wire cage.
2. Place the agitator inside the bowl and line up the horizontal slot on the agitator with the agitator
shaft pins.
3. Slide the agitator up the agitator shaft until it stops and latches (Fig. 6).
To Remove
1. Open the wire cage.
2. Lower the bowl by pressing and holding the down arrow on the bowl switch.
3. Hold the agitator and pull the plunger of the agitator out (Fig. 7). Slide agitator down off the agitator
shaft.
Fig. 7
Fig. 6