Filter
Top Products
– 4 –
PLACING THE ROTOR IN THE OVEN
The rotor must properly engage with the drive mechanism. Orient the rotor so that
the end plate with square drive slots is on the same side of the oven as the drive arm.
STEP 1: Stop the drive arm so it is in the down position (Fig. 1).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 6Fig. 5
MOTOR DRIVE PINS THROUGH DRIVE
SLOTS ON ROTOR END PLATE
STEP 3: Place the drive side of the rotor shaft on the drive arm
support notch (Fig. 3).
STEP 4: Turn the rotor, lining up the square drive slots on the
rotor end plate with the pins on the drive arm (Fig. 4).
STEP 5: Nudge rotor toward the drive arm. Non-drive end of
rotor shaft falls into the lower portion of support
bearing hub (Fig. 5). Drive end of rotor shaft is
driven into center hole of drive arm.
STEP 6: Rotor is now in normal operating position (Fig. 6).
STEP 2: Place the rotor shaft onto upper notch of support
bearing on the non-drive side of the oven (Fig. 2).