Filter
Top Products
– 22 –
Symptom Possible Causes
Machine fills too high or 1. Machine not level - see LEVELING in this manual.
leaks from door. 2. Fill solenoid valve leaking - turn the dishwasher OFF; if water
(Display shows CL/Pr.) continues to come in, contact your local Hobart Service Office.
3. Clean water level probes. (See Cleaning.)
Machine will not drain. 1. Drain pipes restricted - check dishwasher drain line for kinks;
(Display shows E5). ensure proper drain rate is allowed from plumbing.
2. Turn machine OFF. Wait several seconds and then turn back
ON. Repeat this procedure twice if necessary. If problem
persists, contact your local Hobart Service Office.
Some water occasionally This is normal due to expansion of water being heated in the
drips out of rinse arms booster tank.
(H dishwashers only).
Machine displays E6. Contact your local Hobart Service Office.
Machine lights up wrench Contact your local Hobart Service Office.
and flashes P1, P2 or P3.
Machine lights up wrench Refer to Priming Chemical Pumps.
and chemical icon.