Filter
Top Products
– 7 –
DISPOSER STAND
If a disposer stand is to be used, unpack the stand from its shipping carton. The feet may be threaded
in or out as necessary to level the disposer stand.
The disposer flange, adapter plate, gaskets and all hardware required for mounting the disposer are
assembled and packed in a separate container. Refer to the disposer manual shipped with the disposer
and follow the recommendations contained in it. Remove the three mounting bolts and lockwashers
from the disposer flange.
Attach the disposer flange (Fig. 1) and if necessary, the adapter plate (Fig. 1) to the disposer.
NOTE: If a Hobart disposer is used, remove and discard the adapter plate and the smaller of the two
gaskets.
Using the three mounting bolts and lockwashers (previously removed from disposer flange), mount the
disposer and flange assembly to the disposer stand.
Peeler
Position the peeler on top of the disposer stand. Place the peeler drain hose in the hole above the
disposer. Fasten the peeler to the stand using hardware (Fig. 1) shipped in the bag tied to the disposer
stand.
If desired, the disposer stand feet may be bolted to the floor.
PLUMBING
WARNING: PLUMBING CONNECTIONS MUST COMPLY WITH APPLICABLE SANITARY, SAFETY
AND PLUMBING CODES.
Peeler Unit Without Disposer
Using the supplied acorn nuts and gasket, attach the fill tube and bracket assembly (Fig. 1) to the peeler.
Connect a cold water supply to the
1
/2" fill tube coupling (Fig. 1).
NOTE: A globe valve for controlling water supply should be installed in the water supply line at a
location convenient to the operator.
Peeler Unit With Disposer
Using the supplied acorn nuts and gasket, attach the fill tube and bracket assembly (Fig. 1) to the peeler.
Connect the water inlet tubing (Fig. 1) to the
1
/2" fill tube coupling (Fig. 1). Connect the other end of the
water inlet tubing to the fill valve, which is mounted on the disposer stand.
Connect a cold water supply line to the fill valve, which has a
3
/8"-18 N.P.S. female connection.