Filter
Top Products
– 10 –
Turn on the water or disposer, if equipped, and thoroughly clean the interior of the hopper using a mild
soap and brush. Turn off the water or disposer.
If the drawer is equipped with a peel trap, remove the peel trap drawer and thoroughly clean the drawer,
as well as the peel trap interior.
The discharge chute MUST be left open when the unit is NOT in use in order to prolong the life of the
door seal.
MOTOR
This machine is equipped with a manual-reset overload protection switch. If during operation, the motor
should overheat and trip this switch, turn the peeler switch or timer off and allow the motor to cool for
several minutes. To reset the switch, remove the top screw from the round cover plate (Fig. 6), rotate
the cover plate and push the red button (Fig. 6). Install round cover plate and screw onto potato peeler.
If the overload switch persists in tripping, contact your local Hobart Service Office.
PL-41650-1
RED BUTTON
COVER PLATE
Fig. 6
MAINTENANCE
LUBRICATION
The peeler uses sealed ball bearings and therefore, requires no lubrication maintenance.