Filter
Top Products
– 4 –
OPERATION
WARNING: MOVING BEATER IN BOWL. KEEP HANDS, CLOTHING, AND UTENSILS OUT WHILE
IN OPERATION, DO NOT USE WITHOUT INTERLOCKED GUARD.
CONTROLS
All models are furnished with an On-Off toggle switch which controls power to the mixer.
The Bowl Guard must be in position or the mixer will not operate. Refer to page 6.
If the Bowl Support is not all the way up, the mixer will not operate unless the On-Off switch is held in
the up position.
The TIMER (if equipped) is used in conjunction with the On-Off switch for timed mixing operations and
will stop the mixer when the desired time has elapsed.
With the timer set on HOLD, the mixer will run until the On-Off switch is turned to Off.
The GEAR SHIFT LEVER (Fig. 1) is used to change speeds. Always stop the mixer before changing
speeds. To change speeds, turn the switch Off, move the gear shift lever to the desired speed, and
turn the switch back On.
Speed 1 (Low) — This speed is for heavy mixtures such as bread dough, heavy batters, and
potatoes.
Speed 2 (Medium) —This speed is for light dough which must rise quickly, cake batters, and some
whipping operations.
Speed 3 (High) — This is a fast speed for light work such as whipping cream, beating eggs, and
mixing thin batters.
The BOWL LIFT HANDLE (Fig. 1) is used to raise and lower the bowl. To raise the bowl, rotate the
handle upward; rotating the handle downward lowers the bowl.
MIXING
This section explains operation of the mixer and how to install bowls, agitators, and attachments. A
separate
Use and Applications Handbook
is provided with the mixer which contains information on
mixing procedures and outlines specific uses for agitators, attachments, and accessories.
Bowl
New mixer bowls and agitators (beaters, whips, and dough arms) should be thoroughly washed with
hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly
rinsed with clear water BEFORE being put into service. This cleaning procedure should also be
followed for bowls and agitators before whipping egg whites or whole eggs.
The bowl must be installed before the agitator. To install the bowl, fully lower the bowl support (Fig. 1).
Position the bowl so the alignment bracket on the back of the bowl is in the bowl retainer and the
alignment pins (Fig. 1) on the front of the bowl support fit in the holes on the sides of the bowl. Lock
the bowl in place by rotating the bowl clamps (Fig. 1) over the ears of the bowl.
Agitator
To install an agitator (Fig. 1), the bowl must be installed and fully lowered. Place the agitator in the bowl,
push it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the agitator shank.