Filter
Top Products
– 6 –
Bowl Guard (Fig. 2)
The Wire Cage Assembly on the Bowl Guard can be rotated out-of-the-way to add ingredients or
access the bowl and agitator.
To rotate the Wire Cage Assembly to the rear . . .
Rotate the Wire Cage Assembly to the left until it is positioned underneath the Splash Guard. Note
how the grooves on the nylon Retainers allow the Wire Cage to ride around the circular Ridge of the
planetary Drip Cup.
The Wire Cage must be returned to the front and center position for the mixer to operate.
To remove the Wire Cage Assembly for cleaning . . .
Lower the Bowl. Rotate the Wire Cage Assembly to the left until it is positioned underneath the Splash
Guard. Remove both Agitator and Bowl.
While holding the Wire Cage Assembly with both hands, rotate it completely to the left. When the front-
center Retainer reaches the end of its travel, it can be lowered through the flat on the Ridge of the Drip
Cup. After lowering the front-center Retainer, move the Wire Cage Assembly slightly to the rear so
the Rear Retainers clear the Ridge on the Drip Cup. The Wire Cage Assembly can now be lowered
and removed.
Wash the Wire Cage in a sink or dishwasher; rinse with clear water; and dry with a clean cloth.
The stainless steel Splash Guard can be wiped off or washed easily with a cloth or sponge and warm
soapy water. Rinse with clear water. Dry with a clean cloth.
To reinstall the Wire Cage Assembly . . .
Hold the Wire Cage so its top ring is positioned around the planetary Drip Cup with the grooves in both
nylon Rear Retainers straddling the Ridge on the Drip Cup at the rear. Lift the Wire Cage Assembly
so the front-center Retainer passes up through the flat on the Ridge of the Drip Cup and rotate the Wire
Cage Assembly to the right. The Wire Cage is properly assembled when all three Retainers straddle
the Ridge on the Drip Cup in the three opposed locations. Rotate the Wire Cage Assembly to the right
until it stops at the front-center position.
Rotate the Wire Cage out-of-the-way to install or remove the Agitator and Bowl or to add ingredients.
Return the Wire Cage to its front-center position to operate the mixer.
Fig. 2
PL-40562-1
Front-Center
Retainer
Flat
Ridge -
Drip Cup
To Remove:
Rotate Wire Cage to the Left 340 Degrees until
the Front-Center Retainer can be lowered
through the Flat on the Ridge of the Drip Cup.