Filter
Top Products
– 5 –
Fig. 1
To Raise the Bowl While Mixing
To raise the bowl while the agitator is mixing the product (when required by recipe or when using the
Bowl Scraper Attachment): Load ingredients. Close Wire Cage Assembly. Select Low speed. To
begin mixing, hold the On-Off switch in the up position; then raise the bowl.
Attachments
To install an attachment, loosen the thumb screw on the attachment hub (Fig. 1) and remove the plug.
Insert the attachment into the attachment hub making certain that the square shank of the attachment
is in the square driver of the mixer. Secure the attachment by tightening the thumb screw.
Move the gear shift lever to the desired speed and start the mixer to operate the attachment.
The meat and food chopper attachment should be operated in second or third speed. If material in the
cylinder stalls the mixer, stop the mixer at once. DO NOT attempt to restart the mixer in a lower speed
— remove the adjusting ring, knife, plate, and worm and clear the obstruction. THIS ATTACHMENT
MUST NOT BE USED TO CHOP BREAD CRUMBS.
NOTE: Attachment hub should not be used while mixing.
Bowl Scraper Attachment
The Mixer Bowl Scraper Attachment (when ordered) is provided with a separate instruction manual
covering its installation, operation, use and care.
A200
ON
OFF
A200 WITH TIMER
ON
1
HOLD
2
3
4
5
6
7
8
9
10
11
12
13
14
15
OFF
ATTACHMENT HUB
THUMB SCREW
GEAR SHIFT
LEVER
WIRE CAGE
AGITATOR
BOWL
CLAMP
BOWL
SUPPORT
APRON
CONTROL
PANEL
BOWL LIFT
HANDLE
SPLASH
GUARD
BOWL LIFT
SLIDEWAYS
ALIGNMENT
PIN
PL-53477