Filter
Top Products
– 11 –
Do not exceed chemical manufacturer’s recommended
concentrations for detergent or sanitizer. Do not exceed
200 parts per million concentration of available chlorine.
For example, mixing 1 tablespoon of 5.25% sodium
hypochlorite bleach with 1 gallon of water yields a solution
containing 200 ppm of available chlorine. Solution with
concentrations greater than 200 ppm will accelerate
corrosion of metals. Maximum exposure to sanitation
solution varies with temperature and concentration. Rinse
with clean water.
Reassemble the sharpener to the mounting bracket by
sliding the left slot on the sharpener over the left guide pin
on the bracket while tilting slightly (Fig. 7). Then, press
down on the right side of the sharpener so the locking
hole fits over the right guide pin on the bracket. Slide the
Lock Lever to the right to lock the sharpener in position.
Make sure the sharpener is securely engaged to the pins
on the bracket.
Carefully reassemble the Top Knife Cover by putting it in
position (three guide pins). Lock by turning the Latch
Knob to the left while lowering the Top Knife Cover; then,
release the Latch Knob and turn it to the right until snug.
Replace the Deflector below the slicer knife:
Guide
bottom of socket onto mount and rotate upwards.
Make sure the digits etched on the Key (Fig. 8) match the
last three digits of the slicer serial number. To reinstall
the Carriage Tray / Support Arm: Hold it with both hands
and lower it so the Key at the bottom of the Support Arm
fits into the slot of the Carriage Pivot (Fig. 8). The
Carriage Tray should rest almost horizontal (Fig. 4).
Return the Carriage Tray to the Gauge Plate by tilting to
the left. Turn the Knob on the Carriage Tray / Support
Arm clockwise until snug.
To clean under the model 2912PS slicer, raise the Lift
Lever past center to its stop (Fig. 9). After cleaning,
return the slicer to its normal position by slowly retracting
the Lift Lever.
DO NOT wash any slicer components in a dishwasher.
DO NOT immerse slicer base or motor in water.
If using a chlorinated sanitizing solution, dilute per manufacturer’s guidelines. Rinse with fresh water.
NOTE: Failure to follow use, care, and maintenance instructions may void your Hobart warranty.
PL-41275-1
CARRIAGE PIVOT
KEY
CARRIAGE TRAY /
SUPPORT ARM
PL-41402-1
GAUGE PLATE
KNIFE
SHARPENER
LOCK LEVER
PL-41325-1
MODEL 2912PS –
RAISED FOR CLEANING
LIFT LEVER –
RAISED PAST CENTER
Fig. 7
Fig. 8
Fig. 9