Filter
Top Products
– 8 –
KEYBOARD AND DISPLAY ACTIVATION
Manual Mode — With the Lever on Manual (pointing down) the keyboard display and the slicer knife
motor are either both on or both off. The display and slicer knife motor will go off if the Switch Knob
is pushed or if the AutoShutoff feature (when enabled) senses inactivity for a 10 second interval.
Automatic Mode — With the Lever on Automatic (pointing to the right) the keyboard display remains
on only if the Switch Knob is on, the gauge plate is open, and the carriage is either at Home position
or in motion during slicing.
SLICING WITH PRESETS
Using a Preset or Entered Value in Weigh Mode
With the lever on Automatic, press the Mode key until
WEIGH and either LB or OZ is lit to indicate Weigh mode
and the units. The zero indicator,
–>
0
<–
, will be lit if the
platter is empty; press Tare
–>
0
<–
to rezero the platter,
if necessary. Once a Preset value is selected and the
Preset indicator is lit, the entered or Preset value displays
for only 2 seconds, then the platter weight displays. With
the gauge plate set, press [ Slice / Pause ] to begin
Automatic slicing. When the platter weight equals or
exceeds the preset weight, the slicer returns to Home
position and shuts off.
Using a Preset or Entered Value in Count Mode
With the lever on Automatic, press the Mode key until
COUNT is lit to indicate Count mode. Select a Preset
'count' value using the keys. The PRESET indicator is lit,
the Preset value displays, and the slice counter is ready
to count down to zero. With the gauge plate set, press
[ Slice / Pause ] to begin Automatic slicing. After the
counter counts down to zero, the slicer returns to Home
position and shuts off.
POWER-UP (Calibration Test & Error Message)
The scale platform should be clean, free of debris, and properly assembled before connecting electrical
power to the slicer. At power-up, a calibration test is performed and the scale attempts to zero itself.
If the calibration test fails, a three second tone sounds and
CAL
displays as an error message. If
CAL
is displayed — disconnect the electrical plug, re-check the scale platform for proper assembly, and
make sure there is no weight on the scale platform before re-connecting electrical power and repeating
the calibration test. If the
CAL
error message persists, call Service for recalibration.