Filter
Top Products
– 4 –
INSTALLATION CODES AND STANDARDS
The installation of this appliance must be carried out by a licensed installer and in accordance with the
applicable regulations, standards, codes of practice and related publications of the country of
destination.
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF RELEVANT ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.
ELECTRICAL DATA
Model Volts / Hz / Ph Rated Amps
P660 400 / 50 / 3 4
A 26.7 mm hole for installation of electrical conduit is located at the top of the pedestal. Make electrical
connections per the wiring diagram located on the inside of the Top Cover.
Check Rotation
Three-phase machines must be connected so the planetary rotates in the direction of the arrow on the
Drip Cup. To check rotation:
Set the gear shift lever on 1.
Apply power to the mixer and set the Electro-Mechanical Timer on HOLD. With the Bowl Support
all the way up, momentarily run the machine by pushing the START and then STOP buttons.
If rotation is incorrect, DISCONNECT ELECTRICAL POWER SUPPLY and interchange any two
of the incoming power supply leads.