Filter
Top Products
– 6 –
BOWL LIFT
The Handwheel is used to raise and lower the bowl on mixers with the standard bowl lift. Turn the
Handwheel clockwise to raise the bowl or counterclockwise to lower it.
MIXING
This section explains operation of the mixer and how to install bowls and agitators.
Bowl
New mixer bowls and agitators (beaters, whips, and dough arms) should be thoroughly washed with
hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly
rinsed with clear water BEFORE being used.
The bowl must be installed before the agitator.
To install the bowl, fully lower the bowl support. Position the bowl so the alignment bracket on the back
of the bowl is under the retainer on the bowl support and the alignment pins on the front of the bowl
support fit in the holes in the bowl. Lock the bowl in place by rotating the bowl clamps over the ears
of the bowl.
If a bowl adapter is required, install it on the bowl support as you would the bowl and then install the
bowl on the adapter.
Agitator
To install an agitator, the bowl must be installed and fully lowered. Place the agitator in the bowl, push
it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the agitator shank.
To Raise the Bowl While Mixing
To raise the bowl while the agitator is mixing the product (when required by recipe or when using the
Bowl Scraper Attachment): Load ingredients. Close Wire Cage Assembly. To begin mixing, press and
hold the Start button; then raise the bowl.