Filter
Top Products
– 12 –
SYMPTOM POSSIBLE CAUSE
Inadequate rinse. 1. Dirty line strainer causing reduced water flow. Turn off water
supply, remove strainer cap, withdraw and clean screen.
Reassemble.
2. Low supply line pressure.
3. Excessive mineral deposits throughout wash and rinse system.
Deliming may be necessary.
Leaking valve (except solenoid 1. Foreign material preventing proper valve operation. NOTE: A
type). critical period is soon after installation when pipe compound or
metal shavings may lodge at the valve seat. Shut off supply
line. Unscrew and lift bonnet from valve body. Clean valve
and reassemble.
2. If a solenoid valve is malfunctioning, it is recommended that
you contact Service.
No wash tank heat. 1. Circuit breaker to heater tripped.
2. Because of a low water condition, the thermostat turned the
heater off. To reset the thermostat, refer to HEATER, page 7.
3. Over-temperature thermostat may have tripped. Contact
Service.
No or slow fill. 1. Dirty line strainer causing reduced water flow. Turn off water
supply, remove strainer cap, withdraw and clean screen.
Reassemble.
SERVICE
Contact your local Hobart Service Office for any repairs or adjustments needed on this equipment.
FORM 34047 Rev. A (July 2000) PRINTED IN U.S.A.