Hoshizaki AM-50BAE-DS Ice Maker User Manual


  Open as PDF
of 34
 
31
15) Reconnect the suction tube.
16) Hook each separator onto the rail, then pull it hard towards you until it locks into place.
See Fig. 45.
17) Replace the slope in its correct position. See Fig. 46.
Fig. 45
18) Discard the sanitizing solution.
19) Mix a new batch of the sanitizing solution and slowly pour it into the water tank.
20)Movethecontrolswitchtothe"WASH"position.
21) After circulating the sanitizing solution for 15 minutes, move the control switch to the
"OFF"position.
22) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction
tube.
23) Repeat steps 19 through 22 one time.
24)Movethecontrolswitchtothe"ICE"positionandallowtheicemakertooperatefor
2 minutes. This allows the water tank to ll with water.
25)Movethecontrolswitchtothe"WASH"position.
26)Alowthewatertocirculatefor5minutes,thenmovethecontrolswitchtothe"OFF"
position.
27) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction
tube.
28) Repeat steps 24 through 27 two more times to rinse thoroughly.
29) Clean the storage bin liner, door liner, and door gasket with a neutral cleaner. Rinse
thoroughly after cleaning.
30)Movethecontrolswitchtothe"ICE"positiontostarttheautomaticicemakingprocess.
Fig. 46
Separator
Rail
Slope
 previous next