Hoshizaki FS-1022MLH-C Ice Maker User Manual


  Open as PDF
of 57
 
46
8)Plugtheunitintotheelectricaloutlet,thenmovethepowerswitchtothe"ON"position
to start the automatic icemaking process.
9) Replace the front panel in its correct position.
3. Removal and Replacement of Extruding Head
1)Removethefrontpanel,thenmovethepowerswitchtothe"OFF"position.
2)Movethecontrolswitchtothe"DRAIN"position.
3)Movethepowerswitchtothe"ON"position.
4) Allow the water to drain from the evaporator.
5)Movethepowerswitchtothe"OFF"position,thenunplugtheunitfromtheelectrical
outlet.
6) Remove the top and side panels.
7) Remove the strap connecting the spout to the chute assembly, then remove the spout.
8) Remove the cutter bolt and lift off the cutter and washer.
9) Remove the seal bolts and lift off the extruding head.
10) Place the new extruding head in place and tighten down the seal bolts.
11) Replace the washer, cutter, cutter bolt, and spout.
12) Replace the top and side panels in their correct positions.
13)Movethecontrolswitchtothe"ICE"position.
14)Plugtheunitintotheelectricaloutlet,thenmovethepowerswitchtothe"ON"position
to start the automatic icemaking process.
15) Replace the front panel in its correct position.
4. Removal and Replacement of Auger
1)Removethefrontpanel,thenmovethepowerswitchtothe"OFF"position.
2)Movethecontrolswitchtothe"DRAIN"position.
3)Movethepowerswitchtothe"ON"position.
4) Allow the water to drain from the evaporator.
5)Movethepowerswitchtothe"OFF"position,thenunplugtheunitfromtheelectrical
outlet.
6) Remove the top and side panels.
7) Remove the strap connecting the spout to the chute assembly, then remove the spout.
8) Remove the extruding head seal bolts. Using the cutter, lift out the auger assembly.
9) Remove the cutter bolt, cutter, washer, and dowel pin. Remove the extruding head from
the auger and place on the new auger.
10) Install the new auger.
11) Replace the removed parts in the reverse order of which they were removed.
12) Replace the top and side panels in their correct positions.
 previous next