Hoshizaki KM-650MAH Refrigerator User Manual


 
11
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with applicable national, state,
and local regulations.
. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic lm from the panels. If the icemaker is exposed to the
sun or to heat, remove the lm after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specied on the nameplate.
• This icemaker can be installed on a storage bin " wide or wider. Hoshizaki Ice
Storage Bin, Model B-300 series is recommended. For further options, contact your
local Hoshizaki distributor.
• On remote air-cooled model, a remote condenser unit is needed. Hoshizaki Remote
Condenser Unit, Model URC-6F, is recommended.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
towards you.
• Top Panel: Lift up at front slightly, push rearward,
and lift off.
• Side Panel (R): Remove the screw. Slide forward
slightly, and lift off.
• Insulation Panel: Lift up slightly, and pull towards
you.
• Base Cover: Lift up slightly, and pull towards you.
Fig. 1
Top Panel
Front
Panel
Insulation
Panel
Side Panel (R)
Base Cover
Screw
Screw