Filter
Top Products
16
) Connect the refrigerant lines to the appropriate male ttings on the remote condenser
unit rst and then at the icemaker. Make a proper connection as follows:
a. Remove the protective covers from the male tting and female coupling.
b. Apply Polyol Ester (POE) refrigerant oil to the entire male tting, including threads,
o-ring, and diaphragm, before making the connection. See Fig. 7.
CAUTION
Do not use thread sealant on the ttings. Use POE refrigerant oil only.
c. Make sure the male tting and female coupling are properly aligned, then start the
connection by hand to ensure that it is not cross threaded.
d. Tighten the connection with a wrench until it is tight. At this point, the nut has
covered most of the threads on the male tting.
e. Mark a reference line on the female coupling and the remote condenser unit or
icemaker panel. Using a backup wrench on the back of the female coupling, tighten
the six-sided nut of the female coupling an additional 1/6 turn. See Fig. 8.
b) Field Fabricated Line Set Installation
1) Route a 3/8" OD copper tube discharge line and a 1/4" OD copper tube liquid line
between the remote condenser unit and the icemaker. Leave a service loop behind the
icemaker to allow the icemaker to be pulled out for service. See Fig. 6.
CAUTION
1. Ensure that there are no traps and no kinks in the line set.
. Do not coil extra line set. Fabricate the line set to the proper length.
) Insulate the two copper tubes separately.
3) Install Parker quick connect couplings on each end. OS-QUICK, a universal quick
connect coupling kit available as optional equipment from Hoshizaki America, is
recommended.
4) Use an electronic leak detector or soap bubbles to check for leaks. Add a trace of
refrigerant to the system (if using an electronic leak detector), and then raise the
pressure using nitrogen gas (140 PSIG). WARNING! DO NOT use R-404A as a
mixture with pressurized air for leak testing.
5) Evacuate through the charging ports on the Parker quick connect couplings and charge
with R-404A refrigerant vapor to a pressure of 15 to 30 PSIG.
6) Connect the refrigerant lines to the appropriate male ttings on the remote condenser
unit rst and then at the icemaker. Make a proper connection as follows:
a. Remove the protective covers from the male tting and female coupling.
b. Apply Polyol Ester (POE) refrigerant oil to the entire male tting, including threads,
o-ring, and diaphragm, before making the connection. See Fig. 7.
CAUTION
Do not use thread sealant on the ttings. Use POE refrigerant oil only.