Filter
Top Products
4
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Installation
The appliance must only be installed by a
competent person. In the UK, CORGI registered
installers undertake to work to safe and satisfactory
standards.
Before moving your cooker check that it is cool, and
switch off at the cooker control unit. Movement of
your cooker is most easily achieved by lifting the
front as follows:
Open the grill door sufficiently to allow a comfortable
grip on the underside front edge of the oven roof,
avoiding any grill elements. (FIG. C)
! !
! !
! Take care in moving the cooker as it is heavy.
Take care to ensure that any floor covering is not
damaged.
Splashplate optional, apply to Parts Department
(see Back Cover for contact number.)
The following instructions should be read by a
qualified technician to ensure that the appliance is
installed, regulated and technically serviced
correctly in compliance with current regulations.
! Remember to unplug the appliance from the! Remember to unplug the appliance from the
! Remember to unplug the appliance from the! Remember to unplug the appliance from the
! Remember to unplug the appliance from the
mains before regulating the appliance ormains before regulating the appliance or
mains before regulating the appliance ormains before regulating the appliance or
mains before regulating the appliance or
carrying out any maintenance work.carrying out any maintenance work.
carrying out any maintenance work.carrying out any maintenance work.
carrying out any maintenance work.
Positioning
Important:Important:
Important:Important:
Important: this unit may be installed and used only
in permanently ventilated rooms according to the
British Standards Codes Of Practice: B.S. 6172/B.S.
5440, Par. 2 and B.S. 6891 Current Editions. The
following requirements must be observed:
a)a)
a)a)
a) The cooker should not be installed in a bed
sitting room with a volume of less than 20m
3
. If it is
installed in a room of volume less than 5m
3
an air
vent of effective area of 110cm
2
is required, if it is
installed in a room of volume between 5m
3
and 10m
3
a supplementary airvent area of 50cm2 is required, if
the volume exceeds 11m
3
no airvent is required.
However, if the room has a door or a window which
opens directly to the outside no air vent is required
even when the volume is between 5m
3
and 11m
3
.
b)b)
b)b)
b) During prolonged use of the appliance you
may consider it necessary to open a window to the
outside to improve ventilation.
c)c)
c)c)
c) If there are other fuel burning appliances in
the same room, B.S.5440 Part 2 Current Edition,
should, be consulted to determine the requisite air
vent requirements.
Installation of the cooker
For a correct installation of the cooker the following
precautions must be followed:
The height of the cooker can be adjusted by means
of adjustable feet in the plinth (900mm - 930mm).
Adjust the feet by tilting the cooker from the side.
Then install the product into position.
NOTE: This appliance must not be fitted on a
platform.
The cooker is designed to fit between kitchen
cabinets spaced 500mm apart. The space either
side need only be sufficient to allow withdrawal of
the cooker for servicing. It can be used with
cabinets one side or both as well as in a corner
setting. It can also be used free-standing.
Adjacent side walls which project above hob level,
must not be nearer to the cooker than 150mm or
65mm (Fig. A) and should be protected by heat
resistant material. Any overhanging surface or
cooker hood should not be nearer than 750mm(FigA)
a)a)
a)a)
a) The cooker may be located in a kitchen, a
kitchen/diner or bed sitting room, but not in a
bathroom or shower room.
b)b)
b)b)
b) The hoods must be installed according to
the requirements in the hood handbook.
c)c)
c)c)
c) The wall in contact with the back of the
cooker must be of flameproof material.
dd
dd
d
))
))
) The cooker is fitted with a safety chain that
must be attached to a hook, secured to the wall
behind the appliance.
!!
!!
! Some models can have their
gas connection inverted. It is
important to make sure the safety
chain is always situated on the
side which corresponds to the
hose holder (Fig. B).
65 mm min
500 mm min
400 mm min400 mm min
750 mm min
Tall cupboard on the left hand
side of 50cm gas cooker
65 mm min
65 mm min
150 mm min
500 mm min
750 mm min
Tall cupboard on the right hand
side of 50cm gas cooker
Fig.A