Filter
Top Products
To Remove
Dmwers
1.
Remove food from the shelf
above the Sealed and Fresh drawer
and take out the shelf. Take
food
off
the glass cover and out of the drawer.
2. Put your fingers behind the
gasket at the rear of the drawer and
pull forward. Remove the gasket.
\,
..<
\
/
‘“’
5. Pull thedrawer forward. Iiftthe
front to clear stops, and remove the
drawer. If the refrigerator door
doesn’t open completely, pull the
drawer out until it hits the door.
Then lift the drawer up until it is
higher than the drawer supports,
tilt it and take it out.
6.
Iftape
holds Convertible Meat
Pan
co~er
to drawer supports, remove
the tape. Pull drawer partway out.
Reach in, push the rear of the glass
up and, at the same time, back, until
it clears front-corner retainers.
3. Pull
thedrawer
partway out.
Reach in, push the rear of the glass
up; at the same time, push it back
until it clears front-corner retainers.
4. Tilt and remove the cover.
7. Tilt and remove the cover.
17
8. Tilt and remove the drawer.
After cleaning, replace in reverse
order.
\
When drawers and covers are back
in place, reinstall the gasket at the
rear of the Sealed and Fresh drawer.
Fit the end of the plastic drawer
support into the slot on the gasket,
with the rubber gasket flap facing
you. Make sure the gasket snaps
into place.