Filter
Top Products
How to Set the
Door Alarm
You don’t have to set the visual
alarm.
As long as either door is
open, the red DOOR OPEN signal
light flashes.
If the signal light on the
DOOR ALARM pad is glowing,
the beeper alarm is set.
If it’s not,
touch the pad to turn it on.
If either door is open for more than
30 seconds, a recurring beep sounds.
The light goes out and the beeping
stops when you close the door.
There are times when you’ll want
the Door Alarm beeper turned
off.
When you’re rearranging a lot
of food, for example. Just touch the
pad. The light will go out and the
beeping will stop.
Why the Red Warm
Temperature
Li@t Glows.
At first, it’s probably because your
newly installed refrigerator hasn’t
completely cooled down yet. Wait
a few hours for it to cool, and then
the light will go out.
From then on, the red light will
glow whenever temperatures inside
get too high for proper food storage.
If this happens, open the doors
only when absolutely necessary,
and close them as
quic~y
as
possible.
As soon as inside temperatures
return to normal, the light goes out.
How the Solid State
Monitor System
Work.
The word NORMAL is lighted
except when a failure has been
detected.
The STATUS CHECK-RESET pad
has two functions:
1.
You can touch the STATUS
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
2.
You can touch the STATUS
CHECK-RESET pad to erase three
flashing codes immediately. Two
codes (DE and
FF)
cannot be erased
until the condition that caused them
to flash has been corrected (see
page 8).
Deactivating the Door Alarm
beeper does not turn the red DOOR
OPEN light off–it keeps flashing
until the door is closed.
(continued next page)
7