Hotpoint DQ47 Mk2 Oven User Manual


 
39
Care and Cleaning
(BD62 & BD52)
Take particular care not to damage the inner surface of the door inner glass
that is coated with a heat reflective layer. Do not use scouring pads, or
abrasive powder, which will scratch the glass. Ensure that the glass panel is
not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool pad.
For slight soiling
the inner glass panel may be cleaned, while still warm, without removing it from
the door. After cleaning, rinse and dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take care
to support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and unscrew the two screws securing the glass
panel so that the securing brackets can be turned. There is no need to
remove the screws completely.
2. Turn the brackets so that the glass can be removed and cleaned at the
sink (Fig. 1.)
3. The inside of the outer door glass can now be cleaned while still fitted
to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS
IN POSITION.
Refit the door inner glass as follows.
1. NOTE: The inner door glass has a special reflective coating on one side.
Replace the door inner glass so that the statement: “IMPORTANT THIS
FACE TOWARDS THE OVEN” can be read from the inner side of the
door.
2. Turn the two securing brackets back to
their original position to retain the
glass and tighten the screws. (Fig. 2.)
Fig. 1.
Fig. 2.