Hotpoint HAD60 S Range User Manual


 
GB
19
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
! Never use steam cleaners or pressure cleaners
on the appliance.
!
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack.
! The accessories can be washed like everyday
crockery (even in your dishwasher).
! Switch off the electricity supply and allow to
cool before cleaning the cooker.
! Clean the cooker regularly and wipe up spills
soon after they occur to prevent them from
becoming burnt on. Never use biological
washing powder, caustic cleaners, harsh
Care and Cleaning
Ensure the glass panel is not subjected toEnsure the glass panel is not subjected to
Ensure the glass panel is not subjected toEnsure the glass panel is not subjected to
Ensure the glass panel is not subjected to
any sharp mechanical blows. any sharp mechanical blows.
any sharp mechanical blows. any sharp mechanical blows.
any sharp mechanical blows. Take particular
care not to damage the inner surface which is coated
with a heat reflective layer. After cleaning, rinse and
dry with a soft cloth. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
To reassemblethe oven
doors proceed with
inserting the glass
pannels in the reverse
order, pushing gently
every panel directly into
the liners.
BE CAREFUL NOT TO
DAMAGE THE GLASS
PANELS BY PUSHING
THEM TOO HARD.
When refitting the glass make sure it is fitted
correctly i.e. reflective face is fitted the right way
round.
abrasives, scouring pads, steam cleaners,
aerosol cleaners or oven chemical cleaners of
any kind.
! If it is necessary to remove the cooker for
cleaning, ensure that it is cool and beware that
it is heavy (approximately 70 kg 155 lbs).
! To move the cooker forward, open the top oven/
grill door and with both hands positioned under the
roof of the compartment, lift and pull forward.
Replace by pushing the cooker backwards.
! Check that the cooker is level. Take care not to
damage any floor coverings.
OVEN HEAT CLEAN LININGS
The oven side linings are coated with a special
enamel which has a continuous cleaning action.
The higher the oven temperature the more effective the
action. In most cases this cleaning operation will
proceed during normal cooking. However, if roasting is
done frequently, or high temperatures are not used
regularly, it may be necessary to occasionally operate
the oven empty at Mark 8 for about an hour.
It should not normally be necessary to clean the
linings with water, but if desired, wipe them over with a
soapy cloth, followed by a wipe with a damp clean
cloth.
REPLACEMENT OF OVEN LIGHT
BULB
CAUTION: DISCONNECT THE APPLIANCE
FROM THE ELECTRICITY SUPPLY BEFORE
REPLACING THE LAMP TO AVOID THE
POSSIBILITY OF AN ELECTRIC SHOCK.
Light bulbs are not covered by the manufacturer's
guarantee.
A new 25W, 300°C rated SES bulb can be obtained
from your cooker supplier or any major electrical
retailer.
1. Remove the shelves from the oven.
2. Unscrew the lens using a thick cloth to protect your
fingers in the unlikely event of a lens fracture.
3. Unscrew bulb.
4. Fit new bulb and refit lens.
! Do not use the oven lamp as/ for ambient
lighting.