Filter
Top Products
Anadapter maybe used onlyon a 15-ampcircuit,
Donot use an adapter-on a 20-ampcircuit.W%ere
~ocalcodes permit, a~MPOWY
CONNEmON maybe made to a properly
grounded two-prongwallreceptacleby the
use ofa UL-listedadapter,availableat most
hardware stores. The larger slotin the adapter
must be alignedwiththe larger slotin the wall
receptacle to provideproper polarityin the
connectionof the power cord.
m
----. ,
TEMPORARY METHOD
~~
(ADAPTERPLUGS NOT
PERMITTEDIN CANADA)
~@71
ALIGN LARGE
w
w-”
ENSUREPROPER
PRONGS/SLOTS
GROUNDAND
FIRMCONNECTION
BEFORE USE
I
I
CAmON: Attachingthe adapter ground
terminal tothe wallreceptacle coverscrew
does not ground the applianceunless the cover
screw is metal, and not insulated,and the wall
receptacle is grounded through the house
wiring.The customer should havethe circuit
checked by a qualifiedelectricianto make sure
the receptacle is properlygrounded.
t
—
W%en disconnecting the power cord from the
adapter, always hold the adapter with one hand. H
this is not,done, the adapter ground terminal is
very likely to break with repeated use. Should
this happen, DO NOT USE the appliance until a
nroper ground has again been established.
——.
E usageSitiatiolls whereAppfimce Power
Cor<ltill be Disconnected Prequentiy.
t
Do not use an adapter p’lugin these situations :
because disconnecting of the power cord places
undue strain on the adapter and leads to eventual
4
failure of the adapter .grounclterminal. The ~
customer should have the two-prong wall
receptacle replaced with a three-prong
@rounding) receptacle by a qualified electrician
before using the appliance.
The installation of appliances designed for mobi]e
home installation must conform with the
lManufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 (formerly the
Federal Standard for Mobile Home Construction
and Safety,Title 24, HUD, Part 280) or,when
such standard is not applicable, the Standard for
Manufactured Home Installations, latest edition
(Manufactured Home Sites, Communities and
Set-Ups), ~S1 M25.1, latest edition, or with
local codes.
Eie&fri~ois@@nne&f
1. Locate disconnect plug on the range back.
2. Finch sides of connector and pull out of
range back.
M@delsE~ui#~edwiBh ModelsEqwip#@dW$ith
DualsuEn@Fs
seal~d BMrn@n
(
{
y
-..—