Filter
Top Products
3. For better drying results, keep the door
ajar for some minutes before you remove
the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are easily
damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
• There can be water on the sides and door
of the appliance. Stainless steel becomes
cool more quickly than the dishes.
Care and cleaning
Warning! Switch the appliance off before
you clean the filters.
Cleaning the filters
Important! Do not use the appliance without
the filters. Make sure that the installation of the
filters is correct. Incorrect installation will cause
unsatisfactory washing results and damage to
the appliance.
1
2
A
C
B
Fully clean the filters
A, B and C below run-
ning water.
3
1
2
To remove filters B
and C, turn the han-
dle approximately
1/4 anticlockwise.
4
A
Remove the flat filter
A from the bottom of
the appliance.
5
A
D
Put the flat filter A in
the bottom of the ap-
pliance. Install the
flat filter correctly un-
der the two guides D.
6
2
1
Put the filter system in
position. To lock the
filter system, turn the
handle clockwise un-
til it locks in position.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged,
remove remaining parts of soil with a cocktail
stick.
Long periods of non-operation
Do these steps when you do not use the ap-
pliance for a long period:
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Keep the door open to prevent unpleasant
smells.
4. Keep the inner side of the appliance clean
(filters especially).
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth. Only
use neutral detergents. Do not use abrasive
products, scouring pads or solvents (acetone,
trichloroethylene etc...).
ENGLISH 16