Filter
Top Products
Frost precautions
Caution! Do not install the appliance
where the temperature is below 0 °C. The
manufacturer is not responsible for damage
because of frost.
If not possible, empty the appliance and close
the door. Disconnect the water inlet hose and
remove water from the water inlet hose.
What to do if…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution
to the problem yourself, contact your dealer or the After Sales Service.
Problem
Possible cause Solution
• Continuous flash
of the light of the
running pro-
gramme.
• Intermittent audi-
ble signal.
• 1 flash of the end
indicator light.
Malfunction:
The dishwasher
does not fill with wa-
ter.
The water tap is blocked or furred
with limescale.
Clean the water tap.
The water tap is closed. Open the water tap.
The filter in the water inlet hose is
blocked.
Clean the filter.
The connection of the water inlet
hose is not correct. The hose can be
kinked or squashed.
Make sure that the connection is
correct.
• Continuous flash
of the light of the
running pro-
gramme.
• Intermittent audi-
ble signal.
• 2 flashes of the
end indicator
light.
Malfunction:
The dishwasher will
not drain.
There is a blockage in the sink spi-
got.
Clean the sink spigot.
The connection of the water drain
hose is not correct. The hose can be
kinked or squashed.
Make sure that the connection is
correct.
ENGLISH 17