Filter
Top Products
Problem Possible cause Solution
• Continuous flash
of the light of the
running pro-
gramme.
• Intermittent audi-
ble signal.
• 3 flashes of the
end indicator
light.
Malfunction:
The anti-flood de-
vice operates.
Close the water tap and Contact your local After Sales Service.
Malfunction:
The programme
does not start.
The appliance door is not closed. Close the door.
Mains plug is not connected in. Put in the mains.
The fuse has blown out in the
household fuse box.
Replace the fuse.
After the check, switch on the appliance. The programme continues from the point of interrup-
tion. If the malfunction shows again, contact your After Sales Service.
When the cleaning results are not satisfactory:
Problem Possible cause Solution
The dishes are
not clean
The selected washing programme is
not applicable for the type of load
and soil.
Set different washing programme.
The baskets are loaded incorrectly so
that water cannot reach all surfaces.
Load the baskets correctly.
Spray arms do not turn freely because
of incorrect arrangement of the load.
Make sure that the cutlery and dishes
do not block the spray arms.
The filters are dirty or not correctly in-
stalled.
Make sure that the filters are clean
and installed correctly.
The quantity of detergent is too little
or missing.
Make sure that the quantity of deter-
gent in detergent dispenser is correct.
Limescales
particles on the
dishes
The salt container is empty. Fill the salt container with salt.
The water softener is adjusted on a
wrong level.
Set the water softener.
The salt container cap is not closed
correctly.
Make sure that the salt container is
closed correctly.
The dishes are
wet and dull
No rinse aid has been used. Set the rinse aid dosage.
The rinse aid dispenser is empty. Fill the rinse aid dispenser.
ENGLISH 18