Filter
Top Products
Rev 10/8/03
166239002
2
EIMI Cornelius Inc; 1994–2003
166239002
Rev. Level 1
CAUTION: To minimize the possibility of damaging the surface of the painted tower care
must be taken when choosing a cloth. The cloth must be of clean cotton with a deep nap,
or equivalent. If a damp cloth is instructed to use, it must be rinsed out in clean water, the
damp or the dry cloth must be manually fluffed to a softened consistency before using to wipe or
polish the painted tower.
D. For the painted tower, (rather than a stainless steel tower) the painted surface may be cleaned using
mild detergents or most house hold cleaners like “ Fantastik or Mr. Clean”. After cleaning, wipe entire
exterior of the tower with a damp cloth. (Do not use strong soaps, abrasive cleaners or any
cleaner that contains Alcohol) Dry the tower with a clean cloth.
E. The painted tower surface may be waxed after cleaning using “Simoniz” paste wax, Aero Wax or Glo-
Coat. After applying wax, buff the surface with a clean dry cloth to a high luster finish.
2. Clean Dispensing Valves, Post-Mix
A. Remove the valve cover(s) and wash in plain water.
B. Remove the nozzle and the syrup diffuser and wash the parts in plain water.
IMPORTANT:When washing the dispensing valve, care must be taken not to get water on the elec-
trical solenoid.
C. Hold an appropriate container under the dispensing valve. Being very careful not to get water on the
electrical solenoid, slowly pour plain water over the dispensing valve.
D. Install the nozzle and syrup diffuser on the valve.
E. Install the valve cover(s).
3. Clean Dispensing Valves, Pre-Mix
A. Pour clean water over the valve to rinse away any
sticky residue.
B. Using a small round nylon bristle brush, clean the valve spout with plain water.
C. Dry the valve with a clean dry cloth.
4. Clean and Sanitize Ice Bin, Drains and Drip Tray
IMPORTANT:Only trained and qualified persons should perform these cleaning and sanitizing
procedures.
Sanitizing Solution - Household liquid bleech that contains 5.25% sodium hypochlorit concentration, (such as
Hi-Lex or Chlorox).
Prepare the sanitizing solution by mixing 0.5-ounces of household bleech to one gallion of potable water. This
mixture must not exceed 200 PPM of chorine, allowable by the FDA. Use this mixture for all sanitizing proce-
dures.
A. Remove all ice from the ice bin and melt any remaining ice with hot water.
B. Remove ice bin drain strainer by lifting straight up.
C. Prepare a mild detergent solution in 120_ F potable water.
DO NOT use water hotter than 120_F
D. Using a nylon bristle brush (Do Not use a wire brush), clean the cold plate and the interior of the ice
bin with the detergent solution.
E. Pour the remainder of the detergent solution down the drip tray and bin drains. Observe that the solu-
tion flows freely. If not, determine the cause. It may be necessary to replace the drain tubing.