Filter
Top Products
How TO REVERSE
REFRIGERATOR DOOR
DOORS WITH TRIM AND
PANELS
I. Perform all steps listedin How to
Remove the Door and Hinges.
2. Perform removal stepslistedin How
to Remove and Install Handles.
3. Transfer cabinet
plugsand screwsto
opposite side of
cabinet
4. Remove plugs with
flat blade of i
screwdriver
wrapped in masking
tape.
5. Removecenter mullion screws with
Y_6"hex headdriver.
6. Locatedoor stop (B)anddoor cap(A)
on bottom edge of freshfood door.
Removewith aPhillipsscrewdriver.
• Retainallitemsfor laterreplacement
8,
9.
10.
• Trim will slide up approximately Y4"
and release from
door.
Rotate door panel
180° and tape in place.
Remove top door
extension with ¼" hex
head driver. Flip door
extension (A) so notched corner
turns in toward interior of door (B).
Retrieve alternate side door trim
shippedwith refrigerator.Installtrim
by aligningnotches of trim with
metalmountingtabs onsideof door.
• Slidetrim down until piece locks
into place.
• Taptop of trim with rubber mallet
to insuresnugfit_
• Repeat sameprocedure to install
handlesidetrim removedinstep 7.
II. Replace bottom door cap (A)
removed in step 6.Installdoor stop
(B)on opposite sideof door.
How TO INSTALL AND
REMOVE HANDLES
In some cases,handles may need to be
removed to transport unit through tight
spaces,reverse doors, or install panels.
Some models may come with handles
shipped separate from the refrigerator
door.
INSTALLING HANDLES
I. Retrieve handle from shipping
material (somemodels).
2. Locate handle
mountingpostson _ j
faceof door.
i
3. Position handle over mounting J
posts.
4. Tighten set screws(A) _
with a Y_2 Allen _
wrench /
REMOVING HANDLES
I. Locateset screws in handleand
loosen set screws with a Y32"Allen
wrench.
2. Lift handle from handle mounting
poststo remove.
7. Remove side door trim (A) and
handleside trim (13)from door by
tappingbottom edgesupwardwith a
soft rubber mallet.
B
12.Removetapefrom panels.
13.Proceedto next columnto reinstall
handle.
5